Thats my gun...................
Today was my first day at the range in over 4 years. Not just with this rifle, but any rifles. I am a decent shot, but by no means a benchrest or competetive shooter. That being said, I am a tad bit rusty. The rifle way out shot me but I was still thrilled with the outcome, especially considered my lack of trigger/recoil time.
I shot at Kenmore Range (100yard), I was there at noon today. I was concerned. I have had poor luck with Kenmore in the past. I previously held a Range Officer Certification, so safety has always been big for me and was never an issue. I just don't like getting treated like crap...... Which seemed to be the routine there. I was pleasantly surprised to see John Sutton as the Range Officer. Some of you Sno-County guys and Class 3 guys might know him. Anyways, super cool guy, atmosphere was welcoming, everyone there was having a great time.... No "soup-nazi" to kill the mood.
It took me 4 rounds to get to my zero. I took about 5 minute breather and fired 3 shots. I was super happy with the first round. Factory Winchester 180gr SP.
the shot to the left and below the shoot and see were 2 of my sight in shots.
The next 3 were not as good. I'm not sure if it was anticipating the recoil or being over confident from my previous 3 shots, or both.
I switched to a 220gr handload that a fellow Wagunner worked up. The first shot of the 3 rounds pulled to the right. 100% my fault. I flinched just as i fired. The other 2 shots were damn near one ragged circle.
So all told, I fired 13 rounds. I could have shot more but wanted to get some time on the other guns as well. I have no doubt that with more trigger time and some quality hand loads, I should be able to keep my groups a hell of a lot tighter.
Tom builds an amazing rifle. The trigger is outstanding, the fitment and over-all build quality is just unreal. My rifle is truly a tank, and a very precision built tank at that. The optic is a Vortex Viper PST (bought here on Waguns) and GG&G billet steel medium rings. The low rings would not work as the MTU barrel contour requires a slightly higher ring. THe end of May I should have the AAC Titan suppressor in my possesion and will also be refinishing the metal surfaces hopefully this summer. Most likely Cerakote in McMillan or Coyote tan.