XD / XDm How to Vids

[Massivedesign]

Here are some great XD & XDm videos that show you how to work on and modify your XD/XDm.
If you have any videos, please post them up in this thread. Make sure to give credit to any specific author too.

Please note that these videos are not an endorsement for any company and attempting the content in any of these videos should be taken at your own risk. Warranties may be voided.

Springfield Armory XDM introduction video to detail stripping and servicing by Springer Precision

Instructions on how to detail strip of your Springfield Armory XD and XDM slides

Springfield XDM and XD frame detail assembly instructions by Springer Precision Part 1 of 3
Springfield XDM and XD frame detail assembly instructions by Springer Precision Part 2 of 3
Springfield XDM and XD frame detail assembly instructions by Springer Precision Part 3 of 3

XD/XDM magazine release installation by Springer Precision Magazine release

Springfield XDM and XD grip safety detail assembly instructions

All the above videos are created by Springer Precision

[Just in joy]

here is also a link for XD parts I stumbled across.

http://www.pistolgear.com/products.php?id=41

[Just in joy]

http://nwtownsends.smugmug.com/photos/238574776-XL.jpg

Above is a link for a break down on the XD models which is the same as the photo below.

[Massivedesign]

nice

[Just in joy]

I am on the hunt for the XD and XDM info for the site.

[olydemon]

Here is a new XDm Trigger Job video.

[olydemon]

Cool XD functional rendering videos.

[timmytowbowman]

Thanks for the info guys. I have not broke mine down yet, but see it will be a bit different than the Glocks I am use to. The videos are going to be very helpful.

[Massivedesign]

It's easy... Really.

[timmytowbowman]

I admit I am a bit intimidated, but look forward to breaking it down here in the near future. I hope to find someone in the local area, that is able to install my night sites. I hear some folks have to send them off, and I would rather not have to go through that experience.

[The DUDE Abides]

I just picked up a XDM 45 4.5 on Saturday, thanks for the thread.

[Massivedesign]

I admit I am a bit intimidated, but look forward to breaking it down here in the near future. I hope to find someone in the local area, that is able to install my night sites. I hear some folks have to send them off, and I would rather not have to go through that experience.

I'll send you a PM.

[bajarob]

Great thread. Over the years I guess i've always just started pulling shit apart and figuring it out (piece by piece...remove, replace several times for each piece) as I go along. Lay everything out on a while sheet as it comes apart.
I guess with the internet, I now have a better way
Thanks

[joao01]

lot of good info from James (aka XDMan). I can't link to his youtube channel at the moment, but you should be able to find more of his vids:

http://www.tacti-cool.com/detail-disassembly/

[ANZAC]

I admit I am a bit intimidated, but look forward to breaking it down here in the near future. I hope to find someone in the local area, that is able to install my night sites. I hear some folks have to send them off, and I would rather not have to go through that experience.

I sent my slide out for the sights, but if you have a sight pusher tool it shouldn't be too hard.

The rest of pretty much anything on the XD/XDm is a piece of cake.

Note the loaded chamber indicator can get really gummed up. Every second cleaning I pop the roll pin out and clean it really well.