WaGuns.org https://waguns.org/ |
|
My experience on cutting pelican case foam https://waguns.org/viewtopic.php?f=48&t=21446 |
Page 3 of 3 |
Author: | brian [ Thu Jan 30, 2014 11:53 am ] |
Post subject: | Re: My experience on cutting pelican case foam |
deadshot2 wrote: Someone else posted a neat way to cut foam without templates yet still have a neat looking job. Just do the layout in a "Mirror Image", ie butt of rifle to left if you want to end up with it to the right. Then trace all your items with a sharpie, holding it as vertical as possible. Cut the foam and then reverse it in the case. All the sharpie marks are now underneath and the top is clean. I have gone with the reversed sharpie technique before, but I find it easier and cleaner using the paper templates to lay out all the pieces and get it all straight. Then I can hold the wire to the edge of the paper to get nice clean straight lines. |
Author: | BadKarma [ Fri Jul 05, 2019 7:43 pm ] |
Post subject: | Re: My experience on cutting pelican case foam |
Bring it to the top for David. |
Author: | jukk0u [ Fri Jul 05, 2019 8:33 pm ] |
Post subject: | Re: My experience on cutting pelican case foam |
I used a electric carving knife that had a shitty on off button. So not only was holding the "trigger" down problematic, one had to ensure they were keeping the blades perpendicular while wrestling with a length of foam. Very challenging. I'm going to build a wire cutter as you have done. |
Author: | acidfly [ Fri Jul 05, 2019 8:59 pm ] |
Post subject: | Re: My experience on cutting pelican case foam |
Wow, that id very nice!! |
Page 3 of 3 | All times are UTC - 8 hours |
Powered by phpBB® Forum Software © phpBB Group https://www.phpbb.com/ |