So I got a quote on the cost to get and use the CNC to complete the 80% Billet 7075 AR Lower from start to finish.
http://www.wynakosmachine.com/wma_AR_Lower.html
Cost $264

($200 for 80% billet plus $40 for CNC, Plus Tax $24+/-)

Basically saving $20-$30 doing a group buy...

So we need 10 to make this happen.

I'll start so 9 other's needed.

Please send paypal to me. All funds will be refunded if this does not happen or if you decide to back out (funds are locked in once we have 10).

Lead time on these is looking to be 2 months. 0-1 month to get 10 and then 30 days to get WMA setup and a date.

Please note - you have to be there to push your own button on your AR. The machines will be all set up by WMA staff. No work but to push their button they tell us and your 80% is a functional part of your new AR!

Paypal as gift to oldkim@aol.com


PS I'll see about coordinating a suppressor testing at the same time. Or at least fondle what they make up there.

So for $264 that will include the lower being finished?

That's a little steep for me, however if they could throw in something little like engraving or laser engraving name or WaGuns name I would be much more inclined ;)

Sure that'll be $40 more for you...


It is a bit steep. But I say it's a good for better quality 7075 Billet (vs forged) and it's finished with no ATF involvement.

Also to say you made your own "legal" firearm is a new one.


Group buy is CLOSED.
I went ahead and just ordered what they had in stock with the folks I heard from.