Walther CCP recall

[Massivedesign]

http://www.waltherarms.com/ccp-recall/#

Walther Arms has identified a potential condition in Walther CCP pistols that could potentially cause it to discharge if dropped whether the manual safety is engaged (on) or disengaged (off). The safety of our customers is our paramount concern so we have voluntarily initiated this recall because of the possibility of a drop-fire occurring.

Please do not load or fire your Walther CCP pistol and contact us immediately to arrange to have your pistol upgraded free of charge.



If your pistol has already been upgraded, there will be a dot milled onto the back side of the magazine opening.



The upgrade will be done at no charge to you. For free shipping, please enter your information here, and complete the online form, making sure to include the serial number. After completion of the form a confirmation email will be sent including shipping information.

Please note: The serial number is located on the right side of the pistol (circled in red below)



Please submit your information here – http://www.waltherarms.com/ccp-information-submission

Please check this website and all safety notices on a regular basis for current information about your firearms. You may also contact us by phone at 1-866-503-3389, by email at ccprecall@WaltherArms.com or by mail at Walther Arms, Inc., 7700 Chad Colley Boulevard, Fort Smith, AR 72916.


The current time to repair your CCP is approximately 3 weeks from the time we receive it.


We appreciate your assistance and apologize for any inconvenience this may cause you. Thank you for your patience and cooperation.

[jdhbulseye]

BOLO section? Aren't you an admin?

[Massivedesign]

BOLO section? Aren't you an admin?

It was a test for potential new mods, you passed the first of 300 tests. Congrats.

[jdhbulseye]

BOLO section? Aren't you an admin?

It was a test for potential new mods, you passed the first of 300 tests. Congrats.

[Selador]

Is it just me, or does that look like it's trying to be a hi-point?

[cdoniguian]

Sometime last fall, I received my CCP back from Walther after performing the recall work. I was completely disappointed as the trigger was much worse than when I sent it in. It's gravely, grainy and drags through the pull. Half way through the trigger pull it actually sticks and needs more pressure to make it to the break. I re-cleaned it, lubed it, everything I could do on my own, in an attempt to smooth out the trigger pull. No luck. I was so bummed I just put in back in the safe and decided that I would either sell it or contact Walther. Well, I frankly forgot about it until I received a marketing email from Walther. So, I sent them an email explaining the situation, and advised that I'd be stopping by the Walther booth this week at Shot Show to talk to someone. The next day I received three emails in return. The first email contained the RCA form to return the firearm to Walther. The second email was a FedEx shipping label and the third was a request from their technical team, requesting an opportunity to investigate the firearm. That came the same night that I left for Shot Show. So I will meet the technician who emailed me while at Shot Show tomorrow. I'll return the CCP to Walther when I get back home this week. They are making good on my request so I am very happy so far. I'll post up the results when I get the CCP back.